Inspection Procedure C-6

Central Door Locking System: Forgotten Key Prevention Function does not Work Normally.

Forgotten Key Prevention Circuit:

CIRCUIT OPERATION
The ETACS-ECU operates the forgotten key prevention function according to the following switches:
- Key reminder switch: OFF
- Driver's or front passenger's door switch: ON
- Driver's or front passenger's door lock actuator switch: being turned on

The ETACS-ECU operates the forgotten key prevention function under the following conditions:
- Ignition key: inserted into the ignition key cylinder
- Driver's or front passenger's door: open
- Driver's or front passenger's door lock: being locked

TECHNICAL DESCRIPTION (COMMENT)
If the function does not work normally, the input circuit system from the switches or the ETACS-ECU may be defective (refer to "CIRCUIT OPERATION").

TROUBLESHOOTING HINTS
- Malfunction of the key reminder switch
- Malfunction of the driver's or front passenger's door switch
- Malfunction of the driver's or front passenger's door lock actuator switch
- Malfunction of the ETACS-ECU
- Damaged harness wires or connectors

DIAGNOSIS

Required Special Tools:
- MB991223: Test Harness Set
- MB991502: Scan Tool (MUT-II)
- MB991862: SWS monitor kit







STEP 1. Use scan tool to select "ECU CHECK" on the SWS monitor display.
Check the ETACS-ECU.

CAUTION: To prevent damage to scan tool MB991502, always turn the ignition switch to the "LOCK" (OFF) position before connecting or disconnecting scan tool MB991502. Also connect SWS monitor kit MB991862 after turning on scan tool MB991502.

1. Connect scan tool MB991502 to the data link connector.
2. Connect SWS monitor kit MB991862 to the column switch connector.
3. When the ignition switch is turned to the "LOCK" (OFF) position, scan tool MB991502 should show "OK" on the "ETACS ECU" menu.

Q: Is "OK" displayed on the "ETACS ECU" menu?

YES: Go to Step 2.

NO: Refer to Inspection Procedure A-3 "Communication with ETACS-ECU is impossible."










STEP 2. Check the input signal by using service data of the SWS monitor.
Open the driver's or front passenger's door (i.e. driver's or front passenger's door switch is open) in order to check the driver's or passenger's door switch.
Select "ETACS ECU" (DATALIST), and check that normal conditions are displayed on the items described in the table.

Q: Does the scan tool display "DR DOOR SW" as normal condition?

YES: Go to Step 3.

NO: Refer to Inspection Procedure N-4 "ETACS-ECU does not receive a signal from the driver's or the front passenger's door switch."







STEP 3. Check the input signal (by using the Pulse check).
Check the input signals from the following switches:
- Key reminder switch
- Driver's or front passenger's door lock actuator switch

If the switches which are applicable for the input signal check, are operated, check if scan tool MB991502 sounds or not.

Q: Does scan tool MB991502 sound whenever the key reminder switch, the driver's and front passenger's door lock actuator switches are operated?

YES: Replace the ETACS-ECU. The forgotten key prevention function should work normally.

NO:
- Scan tool MB991502 does not sound when the key reminder switch is operated: Refer to Inspection Procedure O-1 "ETACS-ECU does not receive a signal from the key reminder switch."
- Scan tool MB991502 does not sound when the driver's or the front passenger's door lock actuator switch is operated. Refer to Inspection Procedure O-6 "ETACS-ECU does not receive a signal from the driver's door lock actuator switch".