Inspection Procedure 2

Inspection Procedure 2 - Communication w/Scantool Not Possible





1. Turn the ignition key to the "LOCK' position, disconnect the negative battery cable and tape the terminal.

CAUTION: Wait at least 60 seconds after disconnecting the battery cable before doing any further work.

2. Remove the floor console assembly. (Refer to GROUP - Floor Console.)





3. Remove the SDU connector lock by the following procedure.
If there is no notch in the connector lock lever (Type 1)
Place a flat-tipped (-) screwdriver against the lock spring (metal portion) of the SDU connector lock lever, and push the spring horizontally toward the inside of the unit.

CAUTION:
1. Do not use excessive force to raise the lock lever (green).
2. Do not insert the screwdriver into the gap between the lock lever (green) and the lock spring (metal portion).





If there is a notch in the connector lock lever (Type 2)
Place a flat-tipped (-) screwdriver against the lock spring at the lock lever notch and push the spring toward the unit.

CAUTION: Do not use excessive force to raise the lock lever (green).





4. Disconnect the red 14-pin connector from the SDU.