Third-Row Seat Belt Removal/Installation

THIRD-ROW SEAT BELT REMOVAL/INSTALLATION

CAUTION:
- The ELR (emergency locking retractor) has a spring that will unwind if the retractor cover is removed. The spring cannot be rewound by hand. If this occurs, the ELR will not work properly. Therefore, do not disassemble the retractor.

1. Switch the ignition to off.

2. Disconnect the negative battery cable.

3. Partially peel back the seaming welts.

4. Remove the following parts:
a. Sub trunk Sub-Trunk Removal/Installation

b. Trunk end trim Trunk End Trim Removal/Installation

c. Third-row seat Rear - Third-Row Seat Removal/Installation

d. Rear scuff plate Rear Scuff Plate Removal/Installation

5. Remove the bolt A.






6. Remove the trunk side trim.

7. Remove the rear header trim. Rear Header Trim Removal/Installation

8. Detach the bezel from the C-pillar trim.

9. Remove the C-pillar trim. C-Pillar Trim Removal/Installation

10. Remove the bolts B.

11. Remove the third-row seat belt.

12. Install in the reverse order of removal.