Front Suspension - Stabilizer Removal/Installation

FRONT STABILIZER REMOVAL/INSTALLATION

CAUTION:
- Secure the steering wheel using tape or a cable to prevent the steering shaft from rotating after disconnecting the steering shaft. If the steering wheel rotates after the steering shaft and the steering gear and linkage are disconnected, the internal parts of the clock spring could be damaged.

1. Drain the power steering fluid. Testing and Inspection

2. Remove the front under cover A and front under cover B. Front Under Cover Removal/Installation

3. Remove the middle pipe. Service and Repair

4. Remove the transverse member. Front Suspension - Transverse Member Removal/Installation

5. Remove the intermediate shaft installation bolt, and disconnect the steering shaft. Service and Repair

6. Remove the front crossmember component. Front Suspension - Crossmember Removal/Installation

7. Remove in the order indicated in the table.

8. Install in the reverse order of removal.

9. Inspect for front wheel alignment, and adjust it as necessary. Front Wheel Alignment









Front Stabilizer Installation Note

1. Install the stabilizer bar so that the identification mark is on the left side of the vehicle.






Stabilizer Bushing Installation Note

1. Align the outer side of the positioning plate with the stabilizer bushing.






Stabilizer Bracket Installation Note

1. Install the stabilizer bracket so that the arrow is pointed to the front.