Pinpoint Test 36

Pinpoint Test 36: NO COMMUNICATION WITH THE RESTRAINTS CONTROL MODULE (RCM)

Normal Operation
The RCM communicates with the scan tool using ISO 9141 communication mode through the data link connector (DLC).

Possible Causes
A no-communication condition can be caused by:
- damage to circuit (LB/W).
- a damaged DLC.
- a damaged scan tool.
- an RCM internal concern.

WARNING: If the supplemental restraint system (SRS) is being serviced, the system must be deactivated and restraint system diagnostic tools must be installed.

The air bag restraint system diagnostic tools must be removed and the air bag modules reconnected when the system is reactivated to avoid non-deployment in a collision, resulting in possible personal injury.

NOTE: Diagnostics or repairs are not to be performed on a seat equipped with a seat side air bag with the seat in the vehicle. Prior to attempting to diagnose or repair a seat concern when equipped with a seat side air bag, the seat must be removed from the vehicle and the restraint system diagnostic tools must be installed in the seat side air bag electrical connectors. The restraint system diagnostic tools must be removed prior to operating the vehicle over the road.

NOTE: After diagnosing or repairing an SRS, the restraint system diagnostic tools must be removed before operating the vehicle over the road.

NOTE: After diagnosing or repairing a seat system, the restraint system diagnostic tools must be removed before operating the vehicle over the road.

NOTE: The SRS must be fully operational and free of faults before releasing the vehicle to the customer.

Step 1 - 3:

Step 4:

Step 5: