ABS Warning Light Does Not Come On

BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS: ELECTRONICALLY CONTROLLED BRAKE SYSTEM: ABS Warning Light does not Come ON
- ABS Warning Light does not Come ON

DESCRIPTION

The skid control ECU is connected to the combination meter via CAN communication.

WIRING DIAGRAM

Refer to ABS Warning Light Remains ON ABS Warning Light Remains On.

INSPECTION PROCEDURE

NOTICE:
When replacing the skid control ECU, perform initialization and calibration of the linear solenoid valve Initialization.

PROCEDURE

1. CHECK CAN COMMUNICATION SYSTEM

(a) Check if a CAN communication system DTC is output Diagnosis System.

Result:





B -- INSPECT CAN COMMUNICATION SYSTEM How to Proceed With Troubleshooting
A -- Continue to next step.

2. CHECK ABS WARNING LIGHT

(a) Disconnect the skid control ECU connectors.

(b) Turn the power switch on (IG).

(c) Check that the ABS warning light comes on.

OK:

The ABS warning light comes on.

HINT
If troubleshooting has been carried out according to Problem Symptoms Table, refer back to the table and proceed to the next step before replacing the part Problem Symptoms Table.

NG -- INSPECT COMBINATION METER ASSEMBLY

OK -- REPLACE SKID CONTROL ECU Removal

3. INSPECT COMBINATION METER ASSEMBLY

(a) Turn the power switch off.

(b) Reconnect the skid control ECU connectors.

(c) Perform the Active Test of the combination meter (meter CPU) using the Techstream Scan Tool Testing and Procedures.

(d) Check the combination meter.

OK:

The ABS warning light turns on or off in accordance with the Techstream operation.

HINT
If troubleshooting has been carried out according to Problem Symptoms Table, refer back to the table and proceed to the next step Problem Symptoms Table.

NG -- REPLACE COMBINATION METER ASSEMBLY Removal

OK -- REPLACE SKID CONTROL ECU Removal