Removal

NAVIGATION / MULTI INFO DISPLAY: DISPLAY AND NAVIGATION ASSEMBLY: REMOVAL

1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:
* w/ Navigation System:
After the engine switch is turned off, the display and navigation module display (navigation system) records various types of memory and settings. As a result, after turning the engine switch off, be sure to wait for the time specified in the following table before disconnecting the cable from the negative (-) battery terminal.

Waiting Time before Disconnecting Cable from Negative (-) Battery Terminal:





* When disconnecting the cable, some systems need to be initialized after the cable is reconnected Repair Instruction - Initialization.

2. REMOVE INSTRUMENT PANEL FINISH PANEL END LH Removal

3. REMOVE INSTRUMENT PANEL FINISH PANEL END RH Removal

4. REMOVE SHIFT LEVER KNOB SUB-ASSEMBLY Removal

5. REMOVE UPPER CONSOLE PANEL SUB-ASSEMBLY Removal

6. REMOVE FRONT UPPER CONSOLE PANEL GARNISH Removal

7. REMOVE RADIO RECEIVER ASSEMBLY WITH BRACKET Removal

8. REMOVE CENTER INSTRUMENT CLUSTER FINISH PANEL GARNISH Removal

9. REMOVE NO. 2 INSTRUMENT PANEL REGISTER ASSEMBLY Removal

10. REMOVE LOWER INSTRUMENT PANEL FINISH PANEL ASSEMBLY Removal

11. REMOVE DISPLAY AND NAVIGATION MODULE DISPLAY

(a) Remove the 4 bolts.





(b) Pull the display and navigation module display to detach the 7 clips on the backside of the display and navigation module display.





(c) Disconnect the connectors and remove the display and navigation module display.

12. REMOVE NO. 1 RADIO BRACKET

(a) Detach the claw and clamp and remove the connector.





(b) Remove the 3 bolts and No. 1 radio bracket.





13. REMOVE NO. 2 RADIO BRACKET

(a) Remove the 3 bolts and No. 2 radio bracket.





14. REMOVE CENTER INSTRUMENT PANEL REGISTER ASSEMBLY

(a) Detach the 8 claws and remove the center instrument panel register.





15. REMOVE HAZARD WARNING SIGNAL SWITCH ASSEMBLY Removal