Installation

P310 HYBRID TRANSMISSION / TRANSAXLE: SHIFT LEVER:

INSTALLATION

1. INSTALL SHIFT LEVER

(a) Install the floor shift assembly with the 4 nuts.
Torque: 12 Nm (122 kgf-cm, 9 ft-lbf)
NOTE: Tighten them in the order, A, B, C and D.

(b) Install the pattern select switch connector, the shift lock control computer connector and the indicator light wire connector.
2. CONNECT TRANSMISSION CONTROL CABLE ASSEMBLY
(a) Connect the socket of the transmission control cable assembly to the shift lever assembly.

(b) Turn the socket of the transmission control cable assembly clockwise and install the stopper cap.
NOTE: Make sure that the transmission control cable assembly (socket) is firmly secured to the shift lever assembly.

(d) Connect the control cable end to the shift lever assembly.
- Install the transmission control cable assembly with the graduated cuts to face upward to prevent torsion of the inner cable.
- Push the cable end to the bottom of the pin.
- Confirm that the connection between the socket and the shift lock control unit is fixed.

3. INSTALL FLOOR CARPET COVER CENTER LH Installation

4. INSTALL FLOOR CARPET COVER CENTER RH Installation

5. INSTALL GLOVE COMPARTMENT DOOR ASSEMBLY Installation

6. INSTALL INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY NO.2 Installation

7. INSTALL INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY LOWER Installation

8. INSTALL COWL SIDE TRIM SUB-ASSEMBLY LH Installation

9. INSTALL COWL SIDE TRIM SUB-ASSEMBLY RH Installation

10. INSTALL FRONT DOOR SCUFF PLATE RH Installation

11. INSTALL FRONT DOOR SCUFF PLATE LH Installation

12. INSTALL INSTRUMENT PANEL FINISH PANEL LOWER Installation

13. INSTALL CONSOLE PANEL UPPER FRONT Installation

14. INSTALL SHIFT LEVER KNOB

(a) Install the shift lever knob.
15. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
NOTE: When disconnecting the cable, some systems need to be initialized after the cable is reconnected Repair Instruction - Initialization.

16. INSPECT SHIFT LEVER POSITION Adjustments

17. ADJUST SHIFT LEVER POSITION Adjustments

18. INSPECT SHIFT LEVER OPERATION Adjustments