Installation

WIPER / WASHER: FRONT WIPER MOTOR: INSTALLATION

1. INSTALL WINDSHIELD WIPER MOTOR ASSEMBLY

(a) Using a T30 "TORX" socket, install the wiper motor with the 2 screws.
Torque: 7.5 Nm (76 kgf-cm, 66 in-lbf)
(b) Apply MP grease to the crank arm pivot of the windshield wiper motor assembly.

(d) Install the link to the wiper motor.

(e) Install the wiper motor cover with the clamp.
2. INSTALL WINDSHIELD WIPER MOTOR AND LINK

(a) Slide the windshield wiper motor and link assembly as shown in the illustration so that the pin fits into place, and then install the windshield wiper motor and link assembly with the 3 bolts.
Torque: 7.0 Nm (71 kgf-cm, 62 in-lbf)
(b) Connect the connector, attach the clamp and install the wire harness to the cowl top panel.
3. INSTALL COWL TOP VENTILATOR LOUVER SUB-ASSEMBLY

(a) Push in the ventilator louver to attach the 17 claws and install the ventilator louver.
(b) Install the 2 clips.

(a) Attach the 12 clips and 4 clamps to install the hood to cowl top seal.
5. INSTALL FRONT FENDER MAIN SEAL LH

(a) Attach the 3 clips to install the fender main seal.
6. INSTALL FRONT FENDER MAIN SEAL RH
HINT:
Use the same procedures described for the LH side.

7. INSTALL UPPER RADIATOR SUPPORT SEAL Installation

8. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected Repair Instruction - Initialization.

9. INSTALL ENGINE ROOM SIDE COVER LH Installation

10. INSTALL ENGINE ROOM SIDE COVER RH Installation

11. INSTALL FRONT WIPER ARM LH

(a) Stop the wiper motor at the automatic stop position.
(b) Clean the wiper pivot serrations with a wire brush.

(c) Install the wiper arm and blade with the nut. Make sure that the wiper arm and blade come to the position shown in the illustration.
Standard Measurement:

Torque: 25 Nm (255 kgf-cm, 18 ft-lbf)
HINT:
Hold down the wiper arm hinge with your hand while tightening the nut.

12. INSTALL FRONT WIPER ARM RH

(a) Stop the wiper motor at the automatic stop position.
(b) Clean the wiper pivot serrations with a wire brush.

(c) Install the wiper arm and blade with the nut. Make sure that the wiper arm and blade come to the position shown in the illustration.
Standard Measurement:

Torque: 25 Nm (255 kgf-cm, 18 ft-lbf)
HINT:
Hold down the wiper arm hinge with your hand while tightening the nut.

(d) Operate the front wipers while spraying washer fluid on the windshield glass. Make sure that the front wipers function properly and there is no interference with the vehicle body.