VSC Off Indicator Light Does Not Come On

BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS: VEHICLE STABILITY CONTROL SYSTEM: VSC OFF Indicator Light does not Come ON

VSC OFF Indicator Light does not Come ON

DESCRIPTION

When the center differential is locked or the VSC OFF switch is operated, VSC control turns off and the VSC OFF indicator illuminates.

WIRING DIAGRAM





INSPECTION PROCEDURE
NOTICE:
When replacing the master cylinder solenoid, perform zero point calibration Calibration.

PROCEDURE

1. CHECK CAN COMMUNICATION LINE
(a) Turn the engine switch off.
(b) Connect the Techstream to the DLC3.
(c) Turn the engine switch on (IG) and the Techstream on.
(d) Select "CAN Bus Check" from the System Selection Menu screen, and follow the prompts on the screen to inspect the CAN Bus.
OK:
"CAN Bus Check" indicates no malfunctions in CAN communication.
NG -- GO TO CAN COMMUNICATION SYSTEM (HOW TO PROCEED WITH TROUBLESHOOTING)
OK -- Continue to next step.
2. CHECK DTC (for CAN Communication System)
(a) Turn the engine switch off.
(b) Connect the Techstream to the DLC3.
(c) Turn the engine switch on (IG) and the Techstream on.
(d) Check for DTCs How to Proceed With Troubleshooting.

Result





B -- GO TO CAN COMMUNICATION SYSTEM (DIAGNOSTIC TROUBLE CODE CHART)
A -- Continue to next step.
3. CHECK OPERATION OF VSC OFF INDICATOR (ACTIVE TEST)
(a) Turn the engine switch off.
(b) Connect the Techstream to the DLC3.
(c) Turn the engine switch on (IG) and the Techstream on.
(d) Enter the following menus: Body Electrical / Combination Meter / Active Test.
(e) Check the condition of the VSC OFF indicator by operating the Techstream.

Combination Meter





OK:
The indicator turns on when operating the Techstream.
NG -- REPLACE COMBINATION METER ASSEMBLY
OK -- REPLACE MASTER CYLINDER SOLENOID