Reading Diagnostic Trouble Codes

Indicator Check





A. Turn the ignition switch to on while pressing the A/C control AUTO switch and R/F SW simultaneously.





B. Check that all the indicators light up and go off at 1 second intervals 4 times in succession.

HINT:
- After the indicator check is ended, the diagnostic trouble code check begins automatically.
- Press the OFF switch when desiring to cancel the check mode.


DTC Check (Sensor Check)








A. Perform an indicator check. After the indicator check is completed, the system enters the DTC check mode automatically.

B. Read the DTC displayed on the panel. Refer to the list of DTCs when reading the DTCs. (DTCs are out put at the temperature display.)
Diagnostic Trouble Code Descriptions

If the slower display is desired, press the Temperature Control Switch and change it to step operation. Each time the Temperature Control switch is pressed, the display changes by 1 step.

Actuator Check





A. After entering the sensor check mode, press the R/F switch.
B. Since each damper, motor and relay automatically operates at 1 second intervals beginning in order from 20 in the temperature display, check the temperature and air flow visually and by hand.
If a slower display is desired, press the A/C switch and change it to step operation. Each time the A/C switch is pressed, the display changes by 1 step.









HINT:
- The buzzer sounds when the display trouble code changes.
- Code are displayed in order from the smaller to the larger numbers.
- To cancel the check mode, press the OFF switch.





WARNING FOR A/C COMPRESSOR LOCK
If compressor lock occurs during A/C operation, the A/C switch indicator on the A/C control assembly starts blinking. When this occurs, check for compressor lock (DTC 22) using diagnosis trouble code check then proceed to inspect the circuit or the component.