Engine Mount RH

Engine Mount RH
This is a "Trustmark Authoring Standards (TAS) Repair Procedure"
- TAS style procedures can be identified by steps that have no accompanying step text and the magenta color of the electrical connectors and fasteners such as nuts, bolts, clamps or clips.
- TAS removal and installation procedures use a sequence of color illustrations to indicate the order to be followed when removing/disassembling or installing/assembling a component.
- Many of the TAS procedures will have the installation information within the removal steps.
- The TAS color illustrations use a variety of symbols to indicate important details of the procedures. It is important to understand these symbols in order to properly used the TAS procedures.
Refer to How to Use TAS Procedures and TAS Symbol Glossary at Vehicle | Description and Operation for additional information on these TAS procedures.
For additional information, refer to How to Use TAS Procedures How to Use TAS Procedures

Removal

NOTE:
Removal steps in this procedure may contain installation details.

WARNING: Make sure to support the vehicle with axle stands.
1 Raise and support the vehicle.
2 Remove the engine undershield.
For additional information, refer to Engine Undershield Engine Undershield
3 Remove the RH front wheel and tire.
For additional information, refer to Wheel and Tire Service and Repair




4 Remove the fender splash shield extension panel.




5 Support the engine.
Special Service Tool




Support, Engine, 303-1254
6 Remove the engine cover.
For additional information, refer to Engine Cover - 3.2L Service and Repair
7 Remove the stabilizer bar.
For additional information, refer to Engine Upper Support Insulator Engine Upper Support Insulator




M10: 45 Nm
M12: 80 Nm





Torque to: 80 Nm

Installation
1 To install, reverse the removal procedure.