Accessory Shaft: Service and Repair

Accessory Drive Pulley
This is a "Trustmark Authoring Standards (TAS) Repair Procedure"
- TAS style procedures can be identified by steps that have no accompanying step text and the magenta color of the electrical connectors and fasteners such as nuts, bolts, clamps or clips.
- TAS removal and installation procedures use a sequence of color illustrations to indicate the order to be followed when removing/disassembling or installing/assembling a component.
- Many of the TAS procedures will have the installation information within the removal steps.
- The TAS color illustrations use a variety of symbols to indicate important details of the procedures. It is important to understand these symbols in order to properly used the TAS procedures.
Refer to How to Use TAS Procedures and TAS Symbol Glossary at Vehicle | Description and Operation for additional information on these TAS procedures.
For additional information, refer to How to Use TAS Procedures

Removal

NOTE:
Removal steps in this procedure may contain installation details.
1 Remove the cover and disconnect the battery ground cable.
For additional information, refer to Specifications [1][2]Specifications
2 Remove the A/C compressor mounting bracket.
For additional information, refer to Accessory Drive Component Bracket Service and Repair









Special Service Tool




Torx Socket, Accessory Drive Pulley, 303-1284

Special Service Tool




Aligner, Timing Cover, 303-1278

Torque to: 60 Nm

Installation

CAUTION: Make sure that the mating faces are clean and free of foreign material.
1 To install, reverse the removal procedure.