Verification Test VER-2A - Road Test Verification

TEST VER-2A ROAD TEST VERIFICATION
Inspect the vehicle to ensure that all engine components are connected. Reassemble and reconnect all components as necessary.

If this verification procedure is being performed after a No Trouble Code test, do the following:
1. Check to see if the initial symptom still exists.

2. If the initial or another symptom exists, the repair is not complete. Check all pertinent Technical Service Bulletins and return to DTC TEST if necessary.

DTC Test - CODE TO TC TEST CHART (Checking for Trouble Codes)

If this verification procedure is being performed after an OBDII trouble code test, perform VER-5. For all other trouble codes, continue with this verification.

For previously read trouble codes that have not been dealt with, return to DTC TEST and follow the path specified; otherwise continue.

DTC Test - CODE TO TC TEST CHART (Checking for Trouble Codes)

If the powertrain control module has not been changed:
1. Connect the DRB to the PCM data link connector and erase trouble codes.

2. With the DRB, reset all values in the adaptive memory.

3. Disconnect the DRB.

Ensure no trouble code remains by doing the following:
1. If this test is for an NC Relay Control Circuit Code, drive the vehicle for at least five minutes with the NC on. For some of the drive, go at least 40 mph; at some point stop the car and turn the engine off for 10 seconds or more; then restart and continue. Ensure the transmission shifts through all gears. Upon completion of the road test, turn the engine off, and read trouble codes with the DRB.

2. If the repaired code has reset, the repair is not complete. Check all related Technical Service Bulletins and return to DTC TEST if necessary. If another trouble code has set, return to DTC TEST and follow the path specified for that trouble code. If there are no trouble codes, the repair was successful and is now complete.

DTC Test - CODE TO TC TEST CHART (Checking for Trouble Codes)