Body Side Trim

BODY SIDE TRIM


Removal and Installation


CAUTION:
- Wrap the tip of flat-bladed screwdriver with a cloth when removing metal clips from garnishes.
- Never damage the body.
- When removing, always use a remover tool that is made of plastic.

REMOVAL

FRONT PILLAR GARNISH
1. Release front pillar portion of front body side welt.





2. Remove pillar garnish mounting metal clips with a remover tool
(A), and then remove pillar garnish (1).

DASH SIDE FINISHER
1. Remove instrument passenger lower cover. (Passenger side only) Refer to Removal and Installation.
2. Remove kicking plate inner.





3. Remove clip (A).
4. Remove dash side finisher mounting clips with a remover tool
(B), and then remove dash side finisher (1).

FRONT KICKING PLATE OUTER
Remove front kicking plate outer mounting clips with a remover tool





(A), and then remove kicking plate outer (1).

FRONT KICKING PLATE INNER
1. Pull up front kicking plate inner, and disconnect pawls.





2. Remove front kicking plate inner (1).

REAR KICKING PLATE OUTER
Remove rear kicking plate outer mounting clips with a remover tool





(A), and then remove kicking plate outer (1).

REAR KICKING PLATE INNER
1. Pull up rear kicking plate inner (1) to disengage the pawls.





2. Remove rear kicking plate inner.

FRONT BODY SIDE WELT
1. Remove front kicking plate inner.
2. Remove front body side welt.

REAR BODY SIDE WELT
1. Remove rear kicking plate inner.
2. Remove rear body side welt.

CENTER PILLAR LOWER GARNISH
1. Remove front kicking plate inner.
2. Remove rear kicking plate inner.
3. Remove front body side welt.
4. Remove rear body side welt.





5. Remove center pillar lower garnish mounting metal clips with a screwdriver (A), and then remove center pillar lower garnish (1).

CENTER PILLAR UPPER GARNISH
1. Remove center pillar lower garnish.
2. Remove front seat belt floor anchor bolt and front seat belt shoulder anchor bolt. Refer to Exploded View Removal and Installation, "SEAT BELT BUCKLE : Exploded View".





3. Remove center pillar upper garnish mounting metal clips with a screwdriver (A), and then remove center pillar upper garnish (1).

REAR WHEEL HOUSE GARNISH
1. Remove rear seat cushion and rear seatback. Refer to Removal and Installation.
2. Remove rear body side welt.





3. Remove rear wheel house garnish mounting clips using a remover tool (A), and then remove rear wheel house garnish (1).

REAR PILLAR FINISHER
1. Remove rear seat cushion and rear seatback. Refer to Removal and Installation.
2. Remove rear seat belt floor anchor bolt. Refer to Exploded View.
3. Remove rear kicking plate inner.
4. Remove rear body side welt.
5. Remove rear wheel house garnish.





6. Remove pillar finisher mounting clips and metal clips with a remover tool (A), and then remove pillar finisher (1).

INSTALLATION
Install in the reverse order of removal.

CAUTION:
Check that clips are securely fitted in panel holes on body when installing, and then press them in.