Inspection 9: Park/Neutral Position (PNP) Switch Circuit
Inspection 9: Park/Neutral Position (PNP) Switch CircuitINSPECTION PROCEDURE
1. CHECK SELF-DIAGNOSIS RESULTS
Check self-diagnosis results.
Is above displayed on the self-diagnosis display?
YES >> GO TO 2.
NO >> INSPECTION END
2. CHECK DATA MONITOR
Select SLCT LVR POSI in Data Monitor and check Park/Neutral position switch signal.
OK or NG
OK >>
^ Replace ABS actuator and electric unit (control unit).
^ Perform the self-diagnosis, and make sure that the result shows NO DTC IS DETECTED. CONSULT-II / Self-Diagnosis
NG >> GO TO 3.
3. CHECK PARK/NEUTRAL POSITION (PNP) SWITCH
Perform Park/Neutral position switch inspection. Refer to AT-113, DTC P0705 PARK/NEUTRAL POSITION SWITCH. P0705
OK or NG
OK >>
^ Replace ABS actuator and electric unit (control unit).
^ Perform the self-diagnosis, and make sure that the result shows NO DTC IS DETECTED. CONSULT-II / Self-Diagnosis
NG >>
^ Repair or replace malfunctioning components.
^ Perform the self-diagnosis, and make sure that the result shows NO DTC IS DETECTED. CONSULT-II / Self-Diagnosis