Code 0407

The crankshaft position sensor (REF) is located on the oil pan (upper) facing the crankshaft pulley. It detects the TDC (Top Dead Center) signal (120 signal).
The sensor consists of a permanent magnet, core and coil. When engine is running, the gap between the sensor and the crankshaft pulley will periodically change. Permeability near the sensor also changes.
Due to the permeability change, the magnetic flux near the core is changed. Therefore, the voltage signal generated in the coil is changed.
The ECM receives the voltage signal and detects the TDC signal (120 signal).







DIAGNOSTIC CHART




DIAGNOSTIC TROUBLE CODE CONFIRMATION PROCEDURE
CONSULT
1) Turn ignition switch "ON" and select "DATA MONITOR" mode with CONSULT.
2) Start engine and run it for at least 2 seconds at idle speed.

OR

GST
1) Start engine and run it for at least 2 seconds at idle speed.
2) Select "MODE 3" with GST.

OR

NO TOOLS
1) Start engine and run it for at least 2 seconds at idle speed.
2) Turn ignition switch "OFF", wait for at least 5 seconds and then turn "ON".
3) Perform "Diagnostic Test Mode II (Self-diagnostic results)" with ECM.

COMPONENT INSPECTION
Crankshaft position sensor (REF)
1. Disconnect crankshaft position sensor (REF) harness connector.
2. Loosen the fixing bolt of the sensor.
3. Remove the sensor.




4. Visually check the sensor for chipping.




5. Check resistance as shown in the figure.

Resistance: Approximately 470 - 570 Ohms At 20°C (68°F)




WIRING DIAGRAM