Even After the Engine Is Started the ABS Warning Lamp Remains on
Even After The Engine is Started The ABS Warning Lamp Remains ONDETECTING CONDITION (part 2):
INSPECTION PROCEDURES
CHECK DTC OUTPUT
1. Connect the Hi-Scan (pro) to the 16P data link connector located behind the driver's side kick panel.
2. Check the DTC output using Hi-Scan (pro). Is DTC output?
NO
^ Repair circuit indicated by code output.
YES
^ Check instrument cluster.
CHECK INSTRUMENT CLUSTER
Disconnect the cluster connector and turn the ignition switch ON. Does the ABS warning lamp remains ON?
YES
^ Replace the instrument cluster.
NO
^ Check for open the wire.
CHECK FOR OPEN IN THE WIRE
Check for continuity in the wire between cluster and ABS control module. Is there continuity?
YES
^ Replace the ABS control module and recheck.
NO
^ Repair an open in the wire between cluster and ABS control module.