DTC 113

DTC 113: Yaw Rate-lateral Acceleration Sensor (Power Supply)
1. Turn the ignition switch OFF.
2. Disconnect the yaw rate-lateral acceleration sensor 4P connector.
3. Turn the ignition switch ON (II).
4. Measure the voltage between body ground and yaw rate-lateral acceleration sensor 4P connector terminal No. 1.





Is there battery voltage?
YES - Replace the yaw rate-lateral acceleration sensor.
NO - Repair open in the wire between the No. 4 (7.5 A) fuse in the under-dash fuse/relay box and the yaw rate-lateral acceleration sensor.