Removal and Replacement

Flywheel





Removal

1. Remove the clutch disc and pressure plate. For additional information, refer to Clutch Removal and Replacement.

2. Remove the 8 bolts and the flywheel.

Installation

1. Tighten the 8 new bolts in 6 stages.
- Stage 1: Tighten fasteners 1 through 4 in sequence to 20 Nm (177 lb-in).

- Stage 2: Tighten fasteners 1 through 4 in sequence to 35 Nm (26 lb-in).

- Stage 3: Tighten fasteners 1 through 4 in sequence an additional 60 degrees.

- Stage 4: Tighten fasteners 5 through 8 in sequence to 20 Nm (177 lb-in).

- Stage 5: Tighten fasteners 5 through 8 in sequence to 35 Nm (26 lb-in).

- Stage 6: Tighten fasteners 5 through 8 in sequence an additional 60 degrees.





2. Install the clutch disc and pressure plate. For additional information, refer to Clutch Removal and Replacement.

3. Using the scan tool, perform the Misfire Monitor Neutral Profile Correction procedure following the on-screen instructions.