Parking Brake Cable - Rear, LH

Parking Brake Cable - Rear, LH

NOTE: All-Wheel Drive (AWD) vehicles shown, Front Wheel Drive (FWD) vehicles similar.









Removal and Installation

1. With the vehicle in NEUTRAL, position it on a hoist.

2. Relieve the tension in the parking brake cable by loosening the parking brake cable equalizer adjustment nut.





3. Disconnect the LH parking brake cable from the parking brake cable equalizer.

4. Squeeze the tabs and disconnect the LH parking brake cable from the bracket.

5. Remove the 3 parking brake cable bracket bolts.
- To install, tighten to 23 Nm (17 lb-ft).


6. Remove the stabilizer bar link nut and position the stabilizer bar link aside.
- To install, tighten to 23Nm (17 lb-ft).


7. Release the parking brake cable from the brake caliper lever and remove the parking brake cable.

8. To install, reverse the removal procedure.
- Adjust the parking brake cable. For additional information, refer to Parking Brake Cable Adjustment Adjustments.