Speaker Replacement - Front Upper
SPEAKER REPLACEMENT - FRONT UPPERREMOVAL PROCEDURE
1. Remove the trim pad.
IMPORTANT: Ensure that the speaker electrical connector does not fall into the speaker opening.
2. Remove the 3 screws that retain the speaker to the instrument panel (IP) substrate.
3. Disconnect the speaker electrical connector.
4. Remove the speaker from the IP.
INSTALLATION PROCEDURE
1. Install the speaker to the IP.
2. Connect the speaker electrical connector.
NOTE: Refer to Fastener Notice in Service Precautions.
3. Install the 3 speaker retaining screws.
Tighten
Tighten the screws to 2 N.m (18 lb in).
4. Install the trim pad.