Low Traction Indicator Always On

CIRCUIT DESCRIPTION
The LOW TRAC Indicator is controlled by the EBCM. The LOW TRAC Indicator is activated during a traction control event only. When the EBCM detects a low traction condition it supplies a ground for CKT 1656 turning on the LOW TRAC Indicator.

DIAGNOSTIC AIDS
^ It is very important that a thorough inspection of the wiring and connectors be performed. Failure to carefully and fully inspect wiring and connectors may result in misdiagnosis, causing part replacement with reappearance of the malfunction.
^ Thoroughly inspect any circuitry that may be causing the complaint for the following conditions:
- Backed out terminals
- Improper mating
- Improperly formed or damaged terminals
- Poor terminal -to-wiring connections
- Physical damage to the wiring harness
^ The following conditions may cause an intermittent malfunction:
- A poor connection
- Rubbed-through wire insulation
- Dirty or corroded terminals
- A broken wire inside the insulation
^ If an intermittent malfunction exists refer to General Electrical Diagnosis Procedures in Diagnostic Aids for further diagnosis.
^ Zero the J 39200 test leads before making any resistance measurements.