Sunroof Window Replacement - Front

Sunroof Window Replacement - Front

Removal Procedure

1. Open the sunshade.




2. Open the sunroof to the vent position.

Note: Ensure the position disk does not drop off.

3. Remove the sunroof window rear bolts, two on each side.
Remove the 4 bolts.
4. Open the sunroof to half open position.

Note: Ensure the position disk does not drop off.

5. Remove the front window bolts, one on each side.
Remove the 2 bolts.
6. Remove the window.

Installation Procedure




1. Insert the window.
Align and insert the window on one side.





Note: Position disk may not rotate, since it can cause scratches in the rear glass cover.

2. Install the front window.

1. Insert the 2 long position window panes (1) if equipped.
2. Install the 2 screws (3) with washers (2).

3. Close the sunroof until the rear part is in the vent position.

Note: Position disk may not rotate, since it can cause scratches in the rear window.

4. Install the sunroof window rear bolts.

1. Insert the 4 long position window panes.
2. Install the 4 screws with washers.




5. Close the sunroof.
Inspect the gap 11.0 + or -0.3 mm (0.43in).





Caution: Refer to Fastener Caution (Fastener Caution)

6. Tighten the sunroof, rear.
Press the seal lightly down (arrow).

Tighten the 4 bolts to 4 Nm (35 lb in).

7. Open the sunroof to half open position.
8. Tighten the sunroof window front bolts.

Tighten the 2 bolts to 4 Nm (35 lb in).

9. Install the front air deflector covers.
Insert and clip in covers.
10. When replacing the motor. Refer to Sunroof Motor/Actuator Initialization/Teach Process.
11. Verify the operation of the sunroof.
12. Close the sunroof.