Engine Mount Bracket Replacement

Engine Mount and Bracket Replacement

Removal Procedure

- Tools Required
- J 28467-9OA Engine Support Adapters
- J 28467-B Universal Engine Support Fixture

Caution Refer to Battery Disconnect Caution in Service Precautions.





1. Disconnect the negative battery cable.
2. Remove the fuel injector sight shield.
3. Remove the drive belt.
4. Disconnect the intake air temperature (IAT) sensor electrical connector.
5. Remove the air inlet duct from the throttle body.
6. Remove the right and left engine mount struts.
7. Raise and support the vehicle.
8. Remove the right front tire and wheel.
9. Remove the right engine splash shield retainers and splash shield.
10. Remove the power steering oil cooler pipe brackets from the frame.





11. Remove the A/C compressor and A/C compressor mounting bracket from the engine. DO NOT discharge the system. Secure the compressor.
12. Remove the catalytic converter from the right side exhaust manifold.





13. Remove the engine mount lower nuts from the frame.
14. Lower the vehicle.
15. Install the engine support fixture.
16. Use the engine support fixture to raise the engine.
17. Raise the vehicle.





18. Remove the left front engine mount bracket bolts from the engine.





19. Remove the right rear engine mount bracket bolts from the engine.
20. Support the frame with jack stands. Loosen the left side frame bolts. Remove the right side frame bolts. Using the jack stands, lower the frame for the engine mount bracket removal.
21. Remove the engine mount bracket and the engine mount from the engine.





22. Remove the engine mount upper nuts.
23. Remove the engine mount from the engine mount bracket.

Installation Procedure





1. Install the engine mount to the engine mount bracket.

Notice: Refer to Fastener Notice in Service Precautions.

2. Install the engine mount upper nuts.
- Tighten the engine mount upper nuts to 78 Nm (58 ft. lbs.).
3. Install the engine mount and the engine mount bracket to the engine.





4. Install the right rear engine mount bracket bolts to the engine. Hand tighten the bolts.





5. Install the left front engine mount bracket bolts to the engine. Hand tighten the bolts.
6. Tighten the engine mount bracket bolts connecting the engine mount bracket to the engine.
- Tighten the engine mount bracket bolts to 102 Nm (75 ft. lbs.).
7. Using the jack stands raise the frame to the original position.
8. Install the right side frame bolts.
- Tighten the right and left side frame bolts to 180 Nm (133 ft. lbs.).
9. Lower the vehicle.
10. Use the engine support fixture to lower the engine.
11. Raise the vehicle.





12. Install the engine mount lower nuts to the frame.
- Tighten the engine mount lower nuts to 78 Nm (58 ft. lbs.).





13. Install the A/C compressor bracket and bolts to the engine.
- Tighten the A/C compressor bracket bolts to 50 Nm (37 ft. lbs.).
14. Install the A/C compressor and the A/C compressor mounting nuts.
- Tighten the A/C compressor mounting nuts to 30 Nm (22 ft. lbs.).
15. Install the power steering oil cooler pipe brackets to the frame.





16. Install the right engine splash shield and the splash shield retainers.
17. Install the catalytic converter to the right side exhaust manifold.
18. Install the right front tire and wheel.
19. Lower the vehicle.
20. Remove the engine support fixture.
21. Install the right and left engine mount struts.
22. Install the air inlet duct to the throttle body.
23. Connect the intake air temperature (IAT) sensor electrical connector.
24. Install the drive belt.
25. Install the fuel injector sight shield.
26. Connect the negative battery cable.