Drive Plate

Drive Plate

Special tools, testers and auxiliary items required

• Counter Hold Tool (10 - 201)

Removing

• Transmission removed.

- Insert (10 - 201) to loosen the bolts.







The outer surface of the bearing flange at the drive plate could be damaged.

• Use a multipoint socket wrench with a shaft at least 40 mm long to loosen and tighten the drive plate bolts.

- Remove the bolts, drive plate and sensor wheel.

Installing

• Tightening specification, refer to => [ Drive Plate Overview ] Drive Plate Overview.

Install in reverse order, paying attention to the following:

• Replace the drive plate bolts.

• The drive plate in the vehicles automatic transmission 0B6 must not have any needle bearings. Check if a needle bearing is inserted before installing. Remove the needle bearing in the drive plate => [ Needle Bearing on Drive Plate ] Service and Repair.

- Be careful of the alignment bushings during installation.

- Position (10 - 201) to tighten the bolts.