Input Shaft Adjustment, Air Gap, Checking

Input Shaft Adjustment, Air Gap, Checking


Do not let the engine run or tow the vehicle without ATF.

• ATF filled, refer to => [ ATF, Filling for ATF Flush ] ATF, Filling for ATF Flush.

- Drive the vehicle off the hoist.

• For vehicles with air suspension, the vehicle lifting mode must be deactivated.

• ATF filled

- Park the vehicle on a level surface.

• With parking brake released, vehicle may roll forward or backward by itself when in selector lever position N.

- Start the engine.

- Move the selector lever into N.

• Do not engage parking brake.

• Do not operate brake pedal.

- Press accelerator pedal.

• Vehicle should not be allowed to roll.

If vehicle rolls in selector lever position N:

- Adjust selector lever cable.

If selector lever cable adjustment is OK but vehicle still rolls in selector lever position N:

- Input shaft, servicing, refer to => [ Input Shaft, Servicing with 6 Lining Discs ] Input Shaft, Servicing with 6 Lining Discs or => [ Input Shaft, Servicing with 7 Lining Discs ] Input Shaft, Servicing with 7 Lining Discs

• In this case, input shaft adjustment (air gap) was not performed correctly.

If vehicle does not roll in selector lever position N:

The input shaft adjustment with evaluation of air play is OK.

- Carry out ATF flush. Refer to => [ ATF Flush, Testing ] ATF Flush, Testing