Right Flange Shaft

Right Flange Shaft

Special tools, testers and auxiliary items required

• Used oil collection and extraction device (V.A.G 1782)

Removing

• Transmission installed.

- Remove right front wheel.

• Secure brake disc with a wheel bolt.

- Remove front and rear noise insulation by loosening fasteners - 2 - and, if equipped, - arrow -.





- Remove right drive axle.

- Remove mounting bracket for flange shaft - arrows -.





- Place old oil collecting and extracting device (V.A.G 1782) beneath transmission.

- Pull out right flange shaft together with mounting bracket.

Installing

- Clean flange shaft.

- Always replace a damaged seal.

- Replace O-ring - arrow A - in the flange shaft bracket.

- Slide spring - C - with cap outward into hole on end of flange shaft - arrow -.





- Insert flange shaft - B - into transmission housing.

• While sliding in the flange shaft, make sure that spring - C - remains in the flange shaft and does not fall into transmission.

- Tightly bolt mounting bracket for flange shaft - arrows -.





- Install right drive axle.

- Check gear oil level in front final drive => [ Front Final Drive, Checking Gear Oil Level ] Final Drive, Differential (01J Continuously Variable Transmission).

Tightening Specifications