Drive Plate

Drive Plate

Special tools, testers and auxiliary items required

• Counter Hold Tool (10 - 201)

Removing






• The transmission is removed.

- Insert the (10 - 201) to loosen the bolts.


The outer surface of the bearing flange at the drive plate could be damaged.

• Use a multipoint socket wrench with a shaft at least 40 mm long to loosen and tighten the drive plate bolts.

- Remove the bolts and remove the drive plate.

Installing

Install in reverse order, paying attention to the following:

• Tightening specification, refer to => [ Drive Plate Overview ] Drive Plate Overview.

• Replace bolts that are tightened to the specification.

• Vehicles with a manual transmission: There is a needled bearing in the drive plate. Check if the needle bearing is inserted before installing. Needle bearing, removing from and installing on drive plate. Refer to => [ Needle Bearing at Drive Plate, Manual Transmission ] Service and Repair.

- Pay attention to the alignment bushing when installing the drive plate.

- Reposition the (10 - 201) to tighten the bolts.