AMI External Audio Source Connection

AMI External Audio Source Connection

Special tools, testers and auxiliary items required

• Radio Removal Tool (T10057)

• Fiber optic plier repair set (VAS 6223)

• Protective cap for cable connector (VAS 6223/9)

The external audio source connection (R199) (AMI) is installed in the glove compartment.

- Switch off all electrical consumers.

- Remove the key.

Removing

- Open glove compartment.

- Insert the two clips of the (T10057) into the release slits on the external audio source connection until they engage. Points on the grip eyelets of tool face outward.






- Pull external audio source connection out of mounting frame.

- Disconnect all connectors from the external audio source connection.

Versions with MOST Bus

- Connect the (VAS 6223/9) - 1 - to the connector for the MOST Bus - 2 -.






All

- Remove the (T10057) , push locking tabs on external audio source connection to do so.

Removing the Internal Control Unit

- Remove the screw - 2 - on back side (2 Nm).






- Press the tabs - 4 - and - 5 - down then up and remove the control unit from the frame - 1 -.

Installing

- Connect all harness connectors.

- Slide the external audio source connection on the mounting frame until it engages.

Overview, refer to => [ MMI, through 10.2008, Component Overview ] MMI, Through 10.2008, Component Overview.