Starter

Starter

Observe notes on contact corrosion. Refer to => [ Contact Corrosion ] Vehicle Damage Warnings.

Removing





- With ignition switched off, disconnect battery ground wire. Refer to => [ Battery, Disconnecting and Connecting ] Battery, Disconnecting and Connecting.

- Remove the rear noise insulation.

- Disconnect electrical connector - 4 - by sliding locking mechanism back - arrow - and pressing release down.

• The B+ line can only be removed after disconnecting terminal 50 electrical connector.

- Remove B+ line protective cap.

- Remove nut - 2 - and remove B+ wire from solenoid switch.

- Remove bolts - 1 and 3 -.

- Remove starter.

Installing

• Tightening specifications, refer to => [ Starter Assembly Overview ] Starter Assembly Overview.

Install in reverse order of removal, observing the following:

- Install the rear noise insulation.

- Install the air ducts.

- Connect battery. Required actions => [ Connecting ] Battery, Disconnecting and Connecting.