Fender

Fender

Removing

Proceed as follows:

- Remove the headlamp and wheel housing liner trim => [ Headlamp and Wheel Housing Liner Trim ] Headlamp and Wheel Housing Liner Trim.

- Remove the sill panel trim => [ Sill Trim ] .

- Remove the bolts - 1 - and - 2 -.





- Remove the nut - 4 - while counterholding the adjusting bolt => [ (Item 11) Adjustment screw ] Fender Assembly Overview with a hex socket wrench.

- Remove the washer and fender - 3 -.

Installing

• Gap dimensions => [ Fender Gap Dimensions ] .

• Tightening specifications => [ Fender Assembly Overview ] Fender Assembly Overview.

Installation is reverse of removal, but note the following:

- If necessary, adjust the lower edge of the side panel with the adjusting bolt => [ (Item 11) Adjustment screw ] Fender Assembly Overview so it is flush with the door.