Drive Plate

Drive Plate

Special tools, testers and auxiliary items required

• Counter-holder tool (3067)

• Depth gauge

Removing

• Transmission removed.

- Mark drive plate position to crankshaft for reinstallation.

- Insert counter hold (3067) to loosen drive plate bolts.





- Loosen and tighten drive plate bolts diagonally.

- Remove drive plate with washer.

- Remove spacer washer behind.

Installing





• Tightening specifications => [ Drive Plate, Assembly Overview ] Drive Plate Assembly Overview.

- Fasten drive plate to crankshaft with at least 3 used bolts tightened to 30 Nm,

- Measure dimension - a - with depth gauge.

• Specified dimension - a -: 21 to 23 mm.

- If specified value is not met, remove drive plate again and use corresponding shim - 2 - with it.





- If specified value is reached, install washer - 1 -.

• Dimple faces toward transmission side.

The rest of installation is in reverse order of removal, note the following:

• Replace bolts which have been tightened to specifications.

- Use counter hold (3067) to tighten drive plate bolts.