Removal and Replacement

E-pretensioner Unit Replacement

NOTE:

- Do not turn the ignition switch to ON (II) while the e-pretensioner unit connectors are disconnected.

- Do not remove the parking brake cable from the parking brake pedal.

1. Remove the accelerator pedal module. Service and Repair

2. Disconnect the connectors (A) from the e-pretensioner unit (B).

3. Remove the E-pretensioner unit from behind the heater unit.

4. Clear any DTCs. Reading and Clearing Diagnostic Trouble Codes

5. Install the unit in the reverse order of removal.

6. After installing the E-pretensioner unit, make sure the SRS indicator comes on for about 6 seconds after turning the ignition switch to ON (II), then goes off.