Cellular Phone Transceiver: Locations

Battery, Transmitter/receiver Unit - Fuse And Wiring Harness, Overview







1 Positive connection
- Red wire with suitable connection.
2 To terminal 15a
- Connection to terminal 15a.
- Ensure wire is protected by fuse.
- Fuse protection max. 15A
3 Antenna Ground (GND)
- Ensure correct Ground (GND) connection to body.
- The antenna location must be treated with suitable corrosion protection.
4 Transmitter/receiver antenna
- Fitting locations, See table below.
5 Shielded antenna wire
- Wire with coaxial connector
6 Telephone or two-way radio transmitter/receiver unit
7 Wiring harness
- Voltage supply positive via red wire 2.5 mm cross section.
- Voltage supply negative via brown wire 2.5 mm cross section.
- If necessary, wire to terminal 15a via black wire 1.5 mm cross section.
8 Fuse holder
- Install next to battery.
9 To Starter
10 Battery
- Located in the engine compartment at the front left corner.
11 Negative ( - ) wire
12 Body Ground (GND)

Transmitted output and antenna installation locations

Golf 1998 > Jetta 1999 >










NOTE: Deviations from these guidelines (location of antenna, frequency, output) are only permitted in special isolated cases after a single-case test carried out by the EMV center of VW AG in Wolfsburg.

EMV = Electro-magnetic compatibility