Shift Interlock Solenoid: Service and Repair

Selector Lever Lock Solenoid -N110-, Removing And Installing

Removing
- Remove shift mechanism. Shifter A/T
- Remove stop buffer from cable lever.
- Shift selector lever into Tiptronic position, then remove frame.
- Shift selector lever into position "2"
- Lift lever for locking cable, detach from mount and remove from mounting bracket.
- Press out pin for locking pawl with a drift.
- Lift out selector lever lock solenoid -N110- together with locking pawl.

Installing
- Shift selector lever into position "2"
- Insert selector lever lock solenoid -N110- in mounting bracket from above together with locking pawl.
- Carefully drive in pin for locking pawl.
- Use a screwdriver to check that the locking pawl is properly engaged when selector lever is in position "P" and "N"
- Place locking lever in mounting bracket and make sure that it engages properly at both mounts.
- Check operation of locking lever. With selector lever in position "P" locking lever should engage detent and make it impossible to change gear.
- Place frame on mounting bracket (ribbed side up) and insert stop buffer in cable lever.
- Install shift mechanism.