Secondary Air System Components, Removing and Installing

NOTES:
- Components marked with an * are checked by the On Board Diagnostic (OBD).
- Components marked with ** are checked by the Output Diagnostic Test Mode (DTM)


1 - Gasket
- Replace
2 - Combi - valve
- Removing and installing. Combi - Valve, Removing and Installing
3 - Connecting pipe/hose
- To distributor piece at vacuum reservoir on cylinder head cover
4 - Secondary air inlet valve (N112)*/**
- Fastened to cylinder head cover
5 - Connector
- Black, 2 - pin
6 - O - Ring
- Replace if damaged
7 - Secondary air pump relay (J299)*/**
- In relay/fuse box (pushed into cable guide next to brake master cylinder)
8 - Pressure hose
- Ensure seated tightly
- Press together at front to release
9 - 10 Nm
10 - Bracket
11 - Retaining clip
12 - Intake hose
- From upper air filter housing
- Ensure seated tightly
- Press together at front to release
13 - Secondary air pump motor (V101)**
14 - Bracket
- For secondary air pump motor
- Secured to intake manifold
15 - 25 Nm
16 - Intake pipe
17 - Cylinder head