Teves/ATE Caliper

Exploded View Of Teves/ATE Front Brake:

Component Notes And Information

NOTE:
^ During removal and installation procedures, refer to the component location illustration above and component notes below.
^ Separate connector for brake pad wear indicator.
^ To prevent brake fluid spillage draw the brake fluid from the reservoir using a bleeder bottle that is used ONLY for brake fluid.

WARNING: Brake fluid is poisonous and must NEVER be removed by siphoning with your mouth.

CAUTION: After servicing caliper, depress brake pedal firmly several times to seat the pads in their normal operating position.

1 Screw
2 Brake disc
- When worn always replace on both sides
- Remove brake caliper prior to removing
- Brake disc diameter: 288 mm
- Brake disc thickness: 25 mm
- Wear limit: 23 mm
3 Brake pads
- Always replace on both sides
- Pads are different; pad on piston side has retaining spring and has a specified direction of rotation
- Pad thickness: 14 mm
- Wear limit: 7 mm (including backing plate)
4 Retaining spring
- Insert in both brake caliper housing drillings
5 Brake carrier
- Supplied as replacement part assembled with sufficient amount of grease on guide pins
- If protective caps are damaged use repair kit
- Use grease packet supplied to lubricate guide pins
6 Brake caliper housing
- Do not disconnect brake hose when changing brake pads
7 Guide pins
- Tighten to: 25 Nm (18 ft lb)
8 Protective cap
9 Seal
- Always replace
10 Brake hose
11 Banjo bolt
- Tighten to: 30 Nm (22 ft lb)
12 Ribbed bolt
- Tighten to: 125 Nm (92 ft lb)
13 Wheel bearing housing
14 Hex socket head bolt
- Tighten to: 10 Nm (7 ft lb)
15 Speed sensor
- Only on vehicles with ABS
- Before inserting sensor, clean mounting hole inner surface and coat with lubricating paste, G 000 650
16 Splash plate
17 Hex bolt
- Tighten to: 10 Nm (7 ft lb)
18 Speed sensor rotor
- Only on vehicles with ABS
19 Hub
20 Countersunk bolt


Removal