Valve Block Left Front Inlet Solenoid Valve Resistance

1. Turn ignition off.
2. Connect multimeter to terminal No. 11 and No. 35 of the ABS 35-pin connector.
3. Set multimeter to 200 Ohm scale. If reading is not 5-7 ohms, check the following:
a. Measure resistance between valve block contacts No. 1 and No. 7.
b. If reading is not as specified in step 3, replace valve block.
c. If reading is as specified in step 3, find open circuit between valve block contact No. 7 and control unit contact No. 35.