Shift Linkage: Service and Repair

1 Transmission
2 Lever
- For selector shaft
3 Support bracket
- For selector lever cable
4 Bolt
- Tighten to: 10 Nm (7 ft lb)
5 Selector lever cable with guide tube
- Do not bend or kink
- Lightly grease cable eyelet and cable ends before installing
- Boot and protective cover must be undamaged and installed correctly or moisture can enter the selector lever cable; replace if necessary
- Check guide tube for tight fit
- Tighten selector lever cable on anchorage/selector lever housing to 20 Nm (15 ft lb) ensuring recessed side of selector lever cable is towards adjustment screw
- Secure to support bracket with locking element
- Secure to lever/selector shaft with locking washer
6 Corrugated locking element
- For selector lever cable
- Always replace
7 Locking washer
- For selector lever cable
8 Protective sleeve
- Install in selector lever housing before attaching selector lever cable
9 Selector lever housing
- With installed selector lever
- Need not be removed to replace selector lever cable or individual parts of shift mechanism
10 Selector lever
- Removing and installing refer to Replacement. Service and Repair
- Disassembling and assembling, refer to Disassemble/Assemble. Service and Repair
11 Gasket
- Glue to selector lever housing
12 Frame
- For securing console and ignition key lock cable
13 Nut
- Tighten to: 12 Nm (9 ft lb)
14 Bolt
- Tighten to: 12 Nm (9 ft lb)
15 Console
16 Bolt
- Tighten to: 2 Nm (18 inch lb)
17 Cover strip
18 Cover
- With selector indicator
19 Selector lever trim
20 Selector lever handle
- Lightly grease push rod when installing
- Secure with set screw or grub screw
21 Set screw
- Tighten to: 1.5 Nm (14 inch lb)
- Install with D 000 600