Throttle Body: Service and Repair

1 - 8-pin harness connector
- black
- for Throttle Valve Control Module J338
- only disconnect/connect with ignition Switched OFF
2 - 25 Nm (18 ft lb)
3 - Throttle Valve Control Module J338
- components: Throttle Position Actuator V60, Throttle Position sensor G88, Throttle Position sensor G69 and Closed Throttle Position switch F60
- heated by engine coolant
- checking: See 'Throttle Body, Testing and Inspection.' Testing and Inspection
- if Throttle Valve Control Module is replaced, perform "Basic setting" See 'Throttle Body, Testing and Inspection.' Testing and Inspection
4 - Gasket
- replace
5 - Connection
6 - Breather hose
- hose must not contact adjacent components!
- from EVAP canister purge regulator valve N80
- part of EVAP system
7 - Exhaust Gas Recirculation valve
- removing and installing: See 'Computers and Control Systems, Exhaust Gas Recirculation, EGR Valve.' Service and Repair
8 - to Brake-servo vacuum line
9 - Left rear support
- between intake manifold and cylinder head
10 - Intake manifold
- disassembling and assembling: See 'Intake Air Plenum, Service and Repair.' Service and Repair

11 - Vacuum hose
- from junction piece for Fuel Pressure regulator/Secondary Air Injection solenoid valve
12 - Support bracket
- for accelerator cable
- accelerator cable, adjusting See 'Throttle Cable/Linkage.' Adjustments
13 - Oil seal
- replace

Sensor Resistance Graph:

14 - Intake Air Temperature sensor G72*
- 15 Nm (10 ft lb)
- checking: See 'Coolant Temperature Sensor, Testing and Inspection.'

- resistance values See 'Sensor Resistance Graph' above.
15 - 2-pin harness connector
- black
- for Intake Air Temperature sensor
16 - Coolant hose