Installation

BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS: REAR SPEED SENSOR: INSTALLATION

HINT
* Use the same procedure for the LH side and RH side.
* The following procedure is for the LH side.
* If the sensor rotor needs to be replaced, replace the rear axle hub and bearing assembly.
* The rear speed sensor is a component of the rear axle hub and bearing assembly. If the rear speed sensor malfunctions, replace the rear axle hub and bearing assembly.

1. INSTALL REAR AXLE HUB AND BEARING ASSEMBLY

(a) Install the rear axle hub and bearing assembly Installation.

HINT
* If the sensor rotor needs to be replaced, replace the rear axle hub and bearing assembly.
* The rear speed sensor is a component of the rear axle hub and bearing assembly. If the rear speed sensor malfunctions, replace the rear axle hub and bearing assembly.

2. INSPECT REAR AXLE HUB BEARING LOOSENESS Rear Axle Hub

3. INSPECT REAR AXLE HUB RUNOUT Rear Axle Hub

4. INSTALL REAR DISC Installation

5. INSTALL PARKING BRAKE SHOE ADJUSTING HOLE PLUG Installation

6. INSTALL REAR DISC BRAKE CALIPER ASSEMBLY Rear Axle Hub

7. CONNECT SKID CONTROL SENSOR WIRE

(a) Connect the skid control sensor wire connector to the rear speed sensor.

8. CONNECT CABLE TO AUXILIARY BATTERY NEGATIVE TERMINAL

(a) Connect the cable to the negative (-) auxiliary battery terminal Installation.

(b) Connect the reservoir level switch connector.

(c) Clear the DTCs Reading and Clearing Diagnostic Trouble Codes.

9. ADJUST PARKING BRAKE

Adjustments

10. INSTALL REAR WHEEL

Torque : 103 Nm (1050 kgf-cm, 76 ft-lbf)

11. CHECK FOR SPEED SENSOR SIGNAL

Test Mode Procedure