Rear Axle Hub

AXLE AND DIFFERENTIAL: REAR AXLE HUB: ON-VEHICLE INSPECTION

HINT
* Use the same procedure for the RH side and LH side.
* The procedure listed below is for the LH side.

1. REMOVE REAR WHEEL

2. SEPARATE REAR DISC BRAKE CALIPER ASSEMBLY Replacement

3. REMOVE PARKING BRAKE SHOE ADJUSTING HOLE PLUG Removal

4. REMOVE REAR DISC Removal

5. INSPECT REAR AXLE HUB BEARING LOOSENESS

(a) Using a dial indicator, check for looseness near the center of the rear axle hub.





Maximum looseness:

0.05 mm (0.00197 in.)

NOTICE:
* Ensure that the dial indicator is set perpendicular to the measurement surface.
* Keep the magnet of the dial indicator away from the rear axle hub and bearing assembly.

If the looseness exceeds the maximum, replace the rear axle hub and bearing assembly.

6. INSPECT REAR AXLE HUB RUNOUT

(a) Using a dial indicator, check for runout on the surface of the rear axle hub outside the rear axle hub bolts.





Maximum runout:

0.07 mm (0.00276 in.)

NOTICE:
* Ensure that the dial indicator is set perpendicular to the measurement surface.
* Make sure to install the tip of the dial indicator towards the outside of the rear axle hub bolt.
* Keep the magnet of the dial indicator away from the rear axle hub and bearing.

If the runout exceeds the maximum, replace the rear axle hub and bearing assembly.

7. INSTALL REAR DISC Installation

8. INSTALL PARKING BRAKE SHOE ADJUSTING HOLE PLUG Installation

9. INSTALL REAR DISC BRAKE CALIPER ASSEMBLY Replacement

10. ADJUST PARKING BRAKE

Adjustments

11. INSTALL REAR WHEEL

Torque : 103 Nm (1049 kgf-cm, 76 ft-lbf)