Installation

LIGHTING (INT): REAR DOOR COURTESY SWITCH: INSTALLATION

HINT
* Use the same procedure for the RH and LH sides.
* The procedure described below is for the LH side.

1. INSTALL REAR DOOR COURTESY LIGHT SWITCH ASSEMBLY

(a) Using a T30 "TORX" socket wrench, install the rear door courtesy light switch assembly with the screw.

Torque : 6.3 Nm (64 kgf-cm, 56 in-lbf)

HINT
There are 2 diameters for the "TORX" screws: 6 mm (0.236 in.) and 7 mm (0.276 in.). The diameter of a supplied "TORX" screw is 7 mm (0.276 in.).

(b) Connect the connector.

2. INSTALL REAR SIDE SEATBACK ASSEMBLY Installation

3. INSTALL REAR SEAT CUSHION LOCK HOOK Installation

4. INSTALL REAR SEAT CUSHION ASSEMBLY Installation

5. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected Repair Instruction - Initialization.

6. INSPECT SRS WARNING LIGHT

for Separate Type Yaw Rate Sensor: Separate Type Yaw Rate Sensor

for Built-in Type Yaw Rate Sensor: Built-in Type Yaw Rate Sensor