Installation

LIGHTING (INT): FRONT DOOR COURTESY SWITCH: INSTALLATION

HINT
* Use the same procedure for the RH and LH sides.
* The procedure described below is for the LH side.

1. INSTALL FRONT DOOR COURTESY LIGHT SWITCH ASSEMBLY

(a) Using a T30 "TORX" socket wrench, install the front door courtesy light switch assembly with the screw.

Torque : 6.3 Nm (64 kgf-cm, 56 in-lbf)

HINT
There are 2 diameters for the "TORX" screws: 6 mm (0.236 in.) and 7 mm (0.276 in.). The diameter of a supplied "TORX" screw is 7 mm (0.276 in.).

(b) Connect the connector.

2. INSTALL CENTER PILLAR LOWER GARNISH Installation

3. INSTALL REAR DOOR OPENING TRIM WEATHERSTRIP

for LH Side: Installation

for RH Side: Installation

4. INSTALL REAR DOOR SCUFF PLATE Installation

5. INSTALL FRONT DOOR OPENING TRIM WEATHERSTRIP

for LH Side: Installation

for RH Side: Installation

6. INSTALL FRONT DOOR SCUFF PLATE Installation