Reassembly

EXTERIOR PANELS / TRIM: REAR BUMPER: REASSEMBLY

1. INSTALL REAR BUMPER REINFORCEMENT SUB-ASSEMBLY

(a) Install the rear bumper reinforcement sub-assembly with the 6 nuts.





Torque : 61 Nm (622 kgf-cm, 45 ft-lbf)

2. INSTALL REAR BUMPER ENERGY ABSORBER

(a) Engage the 2 guides to install the rear bumper energy absorber.





3. INSTALL WHEEL HOUSE REINFORCEMENT LH

(a) Install the wheel house reinforcement LH with the screw and nut.





(b) Engage the clip.

4. INSTALL WHEEL HOUSE REINFORCEMENT RH

HINT
Use the same procedure as for the LH side.

5. INSTALL REAR BUMPER SIDE RETAINER LH

(a) Engage the 6 claws.





(b) Install the rear bumper side retainer LH with the 3 screws.

6. INSTALL REAR BUMPER SIDE RETAINER RH

HINT
Use the same procedure as for the LH side.

7. INSTALL NO. 1 ULTRASONIC SENSOR RETAINER (w/ Intuitive Parking Assist System) Installation

8. INSTALL NO. 1 ULTRASONIC SENSOR (w/ Intuitive Parking Assist System) Installation

9. INSTALL ULTRASONIC SENSOR CLIP (w/ Intuitive Parking Assist System) Installation

10. INSTALL NO. 2 LUGGAGE ROOM WIRE (w/ Intuitive Parking Assist System)

(a) Connect the 4 connectors.





(b) Engage the 4 clamps to install the No. 2 luggage room wire.