Installation

BRAKE CONTROL: FRONT SPEED SENSOR: INSTALLATION

1. INSTALL FRONT SPEED SENSOR





(a) Install the speed sensor onto the steering knuckle with the bolt.

Torque : 8.5 Nm (87 kgf-cm, 75 in-lbf)

NOTICE:
* Check that the speed sensor tip and installation portion are free of foreign matter.
* Install the speed sensor without turning it from its original installation angle.
(b) Install the clamp onto the shock absorber with the bolt.

Torque : 29 Nm (300 kgf-cm, 22 ft-lbf)

(c) Install the clamp onto the body with the bolt.

Torque : 6.0 Nm (61 kgf-cm, 53 in-lbf)

(d) Install the 3 clips.

(e) Connect the speed sensor connector.

(f) Install the speed sensor clip onto the body.

2. INSTALL FRONT FENDER LINER

(a) Install the front fender liner with the 3 screws, 6 clips and 4 grommets.

NOTICE:
The speed sensor wire should not protrude beyond the front fender liner.

3. INSTALL FRONT WHEEL

Torque : 103 Nm (1,050 kgf-cm, 76 ft-lbf)

4. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

Torque : 5.4 Nm (55 kgf-cm, 48 in-lbf)

5. CHECK VSC SENSOR SIGNAL (w/ VSC)

Test Mode Procedure

6. CHECK ABS SENSOR SIGNAL (w/o VSC)

Test Mode Procedure