Installation

BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS: REAR SPEED SENSOR: INSTALLATION

HINT
* If the sensor rotor needs to be replaced, replace it together with the rear axle hub and bearing assembly.
* The rear speed sensor is a component of the rear axle hub and bearing assembly. If the sensor malfunctions, replace the rear axle hub and bearing assembly.
1. INSTALL REAR AXLE HUB AND BEARING ASSEMBLY

(a) Install the rear axle hub and bearing assembly Installation.

HINT
The rear speed sensor is a component of the rear axle hub and bearing assembly. If the sensor malfunctions, replace the rear axle hub and bearing assembly.

2. INSPECT REAR AXLE HUB BEARING LOOSENESS Rear Axle Hub

3. INSPECT REAR AXLE HUB RUNOUT Rear Axle Hub

4. INSTALL REAR DISC Installation

5. INSTALL REAR DISC BRAKE CALIPER ASSEMBLY Replacement

6. CONNECT NO. 3 PARKING BRAKE CABLE ASSEMBLY Installation

7. CONNECT REAR SPEED SENSOR WIRE

(a) Connect the rear speed sensor wire connector to the rear speed sensor.





8. ADJUST PARKING BRAKE LEVER TRAVEL Adjustments

9. INSPECT REAR DISC BRAKE CYLINDER OPERATION LEVER AND STOPPER CLEARANCE Adjustments

10. INSTALL LOWER INSTRUMENT PANEL FINISH PANEL ASSEMBLY Installation

11. INSTALL COWL SIDE TRIM SUB-ASSEMBLY LH Installation

12. INSTALL FRONT DOOR SCUFF PLATE LH Installation

13. INSTALL REAR WHEEL

Torque : 103 Nm (1050 kgf-cm, 76 ft-lbf)

14. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected Repair Instruction - Initialization.

15. INSTALL REAR NO. 3 FLOOR BOARD Installation

16. INSTALL REAR DECK FLOOR BOX Installation

17. INSTALL REAR NO. 2 FLOOR BOARD (for Separate Type) Installation

18. CHECK FOR SPEED SENSOR SIGNAL

Test Mode Procedure