Power Window Regulator Motor (For Sedan Front Side)

POWER WINDOW REGULATOR MOTOR (For Sedan Front Side)

Power Window Regulator Motor (For Sedan Front Side):

REMOVAL

HINT:
- Use the same procedure for both the RH and LH sides.
- The procedure described below is for the LH side.

1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
2. REMOVE FRONT DOOR LOWER FRAME BRACKET GARNISH
3. REMOVE FRONT ARMREST BASE UPPER PANEL
4. REMOVE FRONT DOOR TRIM BOARD SUB-ASSEMBLY
5. REMOVE OUTER REAR VIEW MIRROR
6. REMOVE FRONT DOOR BELT MOULDING
7. REMOVE FRONT DOOR TRIM BRACKET
8. REMOVE FRONT DOOR SERVICE HOLE COVER
9. REMOVE FRONT DOOR GLASS SUB-ASSEMBLY
10. REMOVE FRONT DOOR WINDOW REGULATOR SUB-ASSEMBLY

11. REMOVE POWER WINDOW REGULATOR MOTOR ASSEMBLY FRONT
a. Using "Torx" socket wrench T25, remove the 3 screws and power window regulator motor.

INSTALLATION

1. INSTALL POWER WINDOW REGULATOR MOTOR ASSEMBLY FRONT
a. Apply MP grease to the sliding and rotating areas of the regulator motor.
b. Using "Torx" socket wrench T25, install the power window regulator motor assembly front with the 3 screws.

Torque: 5.4 N.m (55 kgf.cm, 48 in.lbf)

2. INSTALL FRONT DOOR WINDOW REGULATOR SUB-ASSEMBLY
3. INSTALL FRONT DOOR GLASS SUB-ASSEMBLY
4. INSTALL FRONT DOOR SERVICE HOLE COVER
5. INSTALL FRONT DOOR TRIM BRACKET
6. INSTALL FRONT DOOR BELT MOULDING
7. INSTALL OUTER REAR VIEW MIRROR
8. INSTALL FRONT DOOR TRIM BOARD SUB-ASSEMBLY
9. INSTALL FRONT ARMREST BASE UPPER PANEL
10. INSTALL FRONT DOOR LOWER FRAME BRACKET GARNISH
11. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

Torque: 5.4 N.m (55 kgf.cm, 48 in.lbf)