Crankshaft Main Bearing

MAIN BEARING CAP





Using SST, tighten the bolts in several steps to the specified torque in the sequence shown in the illustration (*1).
SST 09011-38121
Torque 22 N*m (224 kgf*cm, 16 ft.*lbf)





Mark the front of the bearing cap bolts with paint.
Retighten the bearing cap bolts by 90° in the same sequence as step (*1).
Check that the painted mark is now at a 90° angle from the front.


Crankshaft
Crankshaft circle runout
Maximum 0.03 mm (0.0012 in.)
Crankshaft main journal diameter 45.988 to 46.000 mm (1.8106 to 1.8110 in.)
Crankshaft main journal taper and out-of-round
Maximum 0.02 mm (0.0008 in.)
Crankshaft bearing cap set bolt diameter
Standard 7.3 to 7.5 mm (0.287 to 0.295 in.)
Minimum 7.2 mm (0.283 in.)